Toolpack:Creating MTP3 Links B
From TBwiki
(Difference between revisions)
(→List of Parameters) |
(→List of Parameters) |
||
| (One intermediate revision by one user not shown) | |||
| Line 85: | Line 85: | ||
* [[Parameter: MTP3_T22 Timer|T22 Timer]] | * [[Parameter: MTP3_T22 Timer|T22 Timer]] | ||
* [[Parameter: MTP3_T23 Timer|T23 Timer]] | * [[Parameter: MTP3_T23 Timer|T23 Timer]] | ||
| + | * [[Parameter: BSN Request Timer|BSN Request Timer]] | ||
| + | * [[Parameter: Periodic SLTM timer|Periodic SLTM timer]] | ||
* [[Parameter: MTP3_SLTA Timer|SLTA Timer]] | * [[Parameter: MTP3_SLTA Timer|SLTA Timer]] | ||
* [[Parameter: Layer 2 Connect Timer|Layer 2 Connect Timer]] | * [[Parameter: Layer 2 Connect Timer|Layer 2 Connect Timer]] | ||
| Line 95: | Line 97: | ||
|} | |} | ||
</div> | </div> | ||
| − | |||
| − | |||
| − | |||
Latest revision as of 14:55, 15 September 2015
Applies to version(s): v2.8
Once you have created an MTP3 linkset, you must associate MTP3 links with it. This is because the MTP3 links are used to bind with either An MTP2, M2PA, or M2Ua link; they are connected in a one-to-one fashion.
To create an MTP3 link:
1- Click MTP3 in the navigation panel.
2- Select an MTP3 network.
3- Select an MTP3 linkset
4- Click Create New Mtp3 Link in the MTP3 linkset configuration window
5- Configure the new MTP3 link:
- Enter a name for the link
- Under Type of link to bind, select MTP2
- Select an MTP2 link
- Click Create
6- Verify that the "Mtp3Link was successfully created" message appears and that the link appears in the Mtp3 Link list.
List of Parameters
- Depending on the type chosen:
- Link Test Slc
- Libk Test Characters
