Use Cases:TMG Performing M2UA Signaling Relay
From TBwiki
(Difference between revisions)
Nicole Tan (Talk | contribs) |
m |
||
| (6 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| − | + | {{DISPLAYTITLE:TMG Performing MTP2 Signaling Relay over M2UA}} | |
| − | + | ||
| − | + | ||
| − | {{DISPLAYTITLE:TMG Performing | + | |
=== '''''Applies to version(s): v2.9 and above''''' === | === '''''Applies to version(s): v2.9 and above''''' === | ||
| − | In this scenario, all messages from TDM network are relayed to the IP network via Sigtran: M2UA <br /> | + | In this scenario, all messages from TDM network are relayed to the IP network via Sigtran: M2UA. This can be used on a satellite link. <br /> |
| − | [[File: | + | [[File:Diagram_M2UA_Replay_TBwiki.jpg|800px]] |
<br /><br /> | <br /><br /> | ||
<br /> | <br /> | ||
| Line 31: | Line 28: | ||
**No need to configure MTP3 part | **No need to configure MTP3 part | ||
|} | |} | ||
| + | |||
| + | == References == | ||
| + | *[[Toolpack:Protocol_Stack_Settings_B#M2UA.3C-.3EMTP2_Relay|Configuring MTP2 to M2UA relay]] | ||
| + | [[Category:Revise on Major]] | ||
Latest revision as of 11:13, 23 August 2019
Applies to version(s): v2.9 and above
In this scenario, all messages from TDM network are relayed to the IP network via Sigtran: M2UA. This can be used on a satellite link.
Note: This implementation, although based on standards, is proprietary.
Normally, one end is the SG and the other is the MGC.
So in this use case, one of the TMGs simulates the MGC. All of this is transparent to the TDM devices interconnected over IP.
| Configure TMG: M2UA Relay | Configure TMG: M2UA SG |
|---|---|
|
|
