MTP2:Architecture
(clean up) |
Cboulanger (Talk | contribs) |
||
| (4 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| − | + | [[MTP2 Layer|MTP Level 2]] defines the functions and procedures of the signaling system for providing reliable transfer of signaling messages over a signaling link. The MTP2 layer is a service provider to the MTP3 Link layer. The MTP2 layer is a service user of [[Web_Portal_Tutorial_Guide#Line_Interfaces|line interfaces / line services]] as seen in the shown in the figure below. | |
| − | ''' | + | [[Image:MTP2-architecture.jpg|700px]] |
| + | |||
| + | |||
| + | MTP2 is used in conjunction with an above local MTP3 layer. | ||
| + | |||
| + | [[Image:MTP2-layer-hierarchy.jpg|600px| ]] | ||
| + | |||
| + | |||
| + | A MTP2 Link must be associated with one line interface/service. It’s a 1-to-1 association. MTP Level 2 defines the functions and procedures of the signaling system for providing reliable transfer of signaling messages over a signaling link. | ||
| + | |||
| + | |||
| + | '''IMPORTANT NOTE:''' It is important to ensure that the received and transmitted clocks of the line interface/service were synchronized. This can be useful for removing/limiting undesirable FIB and BSN errors. (See section “Clock Configurations” in the TB640 user’s guide.) | ||
| Line 16: | Line 27: | ||
The MTP Level 2 software prevents deadlocks and overload conditions from occurring. | The MTP Level 2 software prevents deadlocks and overload conditions from occurring. | ||
| − | |||
| − | |||
| − | |||
Latest revision as of 21:39, 1 September 2009
MTP Level 2 defines the functions and procedures of the signaling system for providing reliable transfer of signaling messages over a signaling link. The MTP2 layer is a service provider to the MTP3 Link layer. The MTP2 layer is a service user of line interfaces / line services as seen in the shown in the figure below.
MTP2 is used in conjunction with an above local MTP3 layer.
A MTP2 Link must be associated with one line interface/service. It’s a 1-to-1 association. MTP Level 2 defines the functions and procedures of the signaling system for providing reliable transfer of signaling messages over a signaling link.
IMPORTANT NOTE: It is important to ensure that the received and transmitted clocks of the line interface/service were synchronized. This can be useful for removing/limiting undesirable FIB and BSN errors. (See section “Clock Configurations” in the TB640 user’s guide.)
Priorities
No pre-emption of data occurs in the process of being transmitted or requiring retransmission. Only a single congestion priority is supported for ANSI and ITU. For a TTC/NTT link, transmitted data buffers are prioritized based on the priority indicated by MTP Level 3.
Flow control
The MTP Level 2 software regulates data flow when resource utilization (such as buffer pool size or queue length) reaches specifies thresholds. For each threshold, MTP Level 2 performs one of the following actions:
- Informs the layer manager about flow control.
- Sends a link status signal unit with status "B" (busy).
- Sends a flow control indication to the upper layer.
The MTP Level 2 software prevents deadlocks and overload conditions from occurring.
