Toolpack v2.3:Create an SCCP Userpart
(→To Create an SCCP User Part) |
(→To Create an SCCP User Part) |
||
| Line 37: | Line 37: | ||
[[Image:Web_Portal_v2.3_SCCP_Backup_Point_Code_2.png|700px]] | [[Image:Web_Portal_v2.3_SCCP_Backup_Point_Code_2.png|700px]] | ||
| + | |||
| + | *Click 'Save' | ||
| + | *Verify that the 'SccpUserpart was successfully updated' message appears | ||
| + | |||
| + | [[Image:Web_Portal_v2.3_SCCP_Backup_Point_Code_3.png|700px]] | ||
Latest revision as of 09:32, 8 November 2009
The Userpart is the container for the multiple SCCP interfaces. One Userpart is required for each protocol variant.
multiple SCCP userpart can be instantiated within a single SCCP protocol layer. This allows a user application to interface with multiple SS7 SCCP protocol variants at the same time. Only one SCCP userpart is required for a specific variant as it can be assigned to multiple SCCP networks.
A Userpart can easily be seen as a protocol variant that a host application wants to use on the SS7 network.
To Create an SCCP User Part
1. Click 'Create New SCCP User Part' to access the SCCP configuration window.
2. Enter a name for the SCCP user part.
- Select a protocol variant
- Click 'Create' to save the changes
3. Verify that the 'SCCP Userpart was successfully created' message appears.
4. Set an SCCP Backup Point Code
- Select a point code from the menu
- Add the selection using the '<<' arrow button
- Click 'Save'
- Verify that the 'SccpUserpart was successfully updated' message appears
