Toolpack v2.4:Create SS7 Point Codes
From TBwiki
(Difference between revisions)
(Created page with '==To create an SS7 point code:== '''1. Click "Point Codes" in the navigation panel:''' Image:Web_Portal_v2.4_Navigation_Panel_Point_Codes.png '''2. Click "Create New Point…') |
(Added all types of point code (new type: Mask used in M3UA route cfg)) |
||
| (4 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
| − | ==To create | + | ==To create SS7 origination and destination point codes:== |
'''1. Click "Point Codes" in the navigation panel:''' | '''1. Click "Point Codes" in the navigation panel:''' | ||
| Line 12: | Line 12: | ||
*Enter a name for the point code | *Enter a name for the point code | ||
*Select a type (select type-specific parameters) | *Select a type (select type-specific parameters) | ||
| + | **OPC | ||
| + | **DPC | ||
| + | **Mask | ||
| + | *Select a DPC length: | ||
| + | **14 bits | ||
| + | **16 bits | ||
| + | **24 bits | ||
*Enter a point code | *Enter a point code | ||
| − | *Click "Create" to | + | *Click "Create" to finalize the configuration |
| + | In this example, a Destination Point Code (DPC) was created. | ||
[[Image:Web_Portal_v2.4_Creating_Point_Code.png|700px]] | [[Image:Web_Portal_v2.4_Creating_Point_Code.png|700px]] | ||
Latest revision as of 10:53, 9 February 2010
To create SS7 origination and destination point codes:
1. Click "Point Codes" in the navigation panel:
2. Click "Create New Point Code" in the point code information panel:
3. Configure the new point code:
- Enter a name for the point code
- Select a type (select type-specific parameters)
- OPC
- DPC
- Mask
- Select a DPC length:
- 14 bits
- 16 bits
- 24 bits
- Enter a point code
- Click "Create" to finalize the configuration
In this example, a Destination Point Code (DPC) was created.
4. Verify that the "MTP3PointCode was successfully created" message appears:
