Toolpack v2.4:Create an MTP3 Configuration
From TBwiki
(Difference between revisions)
(→To create an MTP3 configuration:) |
|||
| (7 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
| − | [[ | + | [[MTP3_Layer|MTP3]] provides message routing between signaling points in an SS7 network. |
==To create an MTP3 configuration:== | ==To create an MTP3 configuration:== | ||
| Line 10: | Line 10: | ||
*Enter a name for the MTP3 configuration | *Enter a name for the MTP3 configuration | ||
| − | *Select | + | *Set Enabled status: |
| − | *Click "Save" to | + | *Select SP as the signalling point type |
| + | *Set SSf validation: | ||
| + | *Select a restart procedure: | ||
| + | **None | ||
| + | **ITU88 (protocol variant) | ||
| + | **ITU92 (protocol variant) | ||
| + | **[[ANSI]] | ||
| + | *Set a value for "Transfer Restricted Required": | ||
| + | *Click "Save" to finalize the configuration | ||
[[Image:Web_Portal_v2.4_Creating_MTP3.png|700px]] | [[Image:Web_Portal_v2.4_Creating_MTP3.png|700px]] | ||
Latest revision as of 09:32, 16 January 2010
MTP3 provides message routing between signaling points in an SS7 network.
To create an MTP3 configuration:
1. Select "MTP3" from the navigation panel:
2. Configure the new MTP3 service:
- Enter a name for the MTP3 configuration
- Set Enabled status:
- Select SP as the signalling point type
- Set SSf validation:
- Select a restart procedure:
- None
- ITU88 (protocol variant)
- ITU92 (protocol variant)
- ANSI
- Set a value for "Transfer Restricted Required":
- Click "Save" to finalize the configuration
3. Verify that the "Mtp3Cfg was successfully updated" message appears:
