Toolpack v2.4:Create an MTP3 Configuration

From TBwiki
(Difference between revisions)
Jump to: navigation, search
(To create an MTP3 configuration:)
(To create an MTP3 configuration:)
 
(One intermediate revision by one user not shown)
Line 11: Line 11:
 
*Enter a name for the MTP3 configuration
 
*Enter a name for the MTP3 configuration
 
*Set Enabled status:
 
*Set Enabled status:
*Select [[SP]] as the signalling point type
+
*Select SP as the signalling point type
 
*Set SSf validation:
 
*Set SSf validation:
 
*Select a restart procedure:
 
*Select a restart procedure:
 
**None
 
**None
**[[ITU88]]
+
**ITU88 (protocol variant)
**[[ITU92]]
+
**ITU92 (protocol variant)
 
**[[ANSI]]
 
**[[ANSI]]
 
*Set a value for "Transfer Restricted Required":
 
*Set a value for "Transfer Restricted Required":

Latest revision as of 09:32, 16 January 2010

MTP3 provides message routing between signaling points in an SS7 network.

To create an MTP3 configuration:

1. Select "MTP3" from the navigation panel:

Web Portal v2.4 Navigation Panel MTP3.png

2. Configure the new MTP3 service:

  • Enter a name for the MTP3 configuration
  • Set Enabled status:
  • Select SP as the signalling point type
  • Set SSf validation:
  • Select a restart procedure:
    • None
    • ITU88 (protocol variant)
    • ITU92 (protocol variant)
    • ANSI
  • Set a value for "Transfer Restricted Required":
  • Click "Save" to finalize the configuration

Web Portal v2.4 Creating MTP3.png

3. Verify that the "Mtp3Cfg was successfully updated" message appears:

Web Portal v2.4 MTP3 Created.png

Personal tools