Toolpack:Creating an M2PA SAP A
From TBwiki
(Difference between revisions)
(Created page with 'To create a new M2PA service access point (SAP): 1- Select '''M2PA''' from the navigation panel Image:Toolpack_v2.5_Navigation_Panel_M2PA.png 2- Click '''Create new M2pa Sā¦') |
|||
| (6 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
| ā | + | === '''''Applies to version(s): v2.5, v2.6.''''' === | |
| + | {{DISPLAYTITLE:Creating an M2PA SAP}} | ||
| + | Now that you have created an M2PA configuration, you must create a new M2PA service access point (SAP) for your system. The SAP is an identifying label for endpoints in your network. | ||
| + | |||
| + | To create a new M2PA SAP: | ||
| + | |||
1- Select '''M2PA''' from the navigation panel | 1- Select '''M2PA''' from the navigation panel | ||
| Line 17: | Line 22: | ||
[[Image:Toolpack_v2.5_Creating_M2PA_SAP.png]] | [[Image:Toolpack_v2.5_Creating_M2PA_SAP.png]] | ||
| ā | 4- Verify that the '''M2pa Sap was successfully created''' message appears | + | 4- Verify that the '''"M2pa Sap was successfully created"''' message appears |
[[Image:Toolpack_v2.5_M2PA_SAP_Created.png]] | [[Image:Toolpack_v2.5_M2PA_SAP_Created.png]] | ||
| Line 27: | Line 32: | ||
[[Image:Toolpack_v2.5_M2PA_SAP_IP_Interface.png]] | [[Image:Toolpack_v2.5_M2PA_SAP_IP_Interface.png]] | ||
| + | |||
| + | |||
| + | ==List of Parameters== | ||
| + | |||
| + | * [[Parameter: Name|Name]] | ||
| + | * [[Parameter: SCTP Source Port|SCTP Source Port]] | ||
Latest revision as of 09:56, 15 July 2013
Applies to version(s): v2.5, v2.6.
Now that you have created an M2PA configuration, you must create a new M2PA service access point (SAP) for your system. The SAP is an identifying label for endpoints in your network.
To create a new M2PA SAP:
1- Select M2PA from the navigation panel
2- Click Create new M2pa Sap
3- Configure the new M2PA SAP:
- Enter a name for the SAP
- Enter an SCTP source port for the SAP
- Click Create
4- Verify that the "M2pa Sap was successfully created" message appears
5- Associate IP interfaces
- Select an IP interface from the list in the information panel
- Click the "<<" button to add the selected IP interface. This is the outgoing route from the hardware adapter.
