Toolpack:Creating an MTP3 Linkset A
From TBwiki
(Difference between revisions)
| (6 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
| − | Now that you have created an MTP3 network, you are ready to create an MTP3 linkset. This can be done through the MTP3 network configuration window | + | === '''''Applies to version(s): v2.5, v2.6., v2.7''''' === |
| + | {{DISPLAYTITLE:Creating an MTP3 Linkset}} | ||
| + | Now that you have created an MTP3 network, you are ready to create an MTP3 linkset. This can be done through the MTP3 network configuration window. A linkset is used to logically combine multiple MTP3 links going to the same DPC into a single entity. One linkset could be the links between a point code identifying the Tmedia/Tdev SS7 node and a point code identifying the adjacent SS7 equipment. | ||
To create an MTP3 linkset: | To create an MTP3 linkset: | ||
| + | |||
1- Click '''Create New Mtp3 Linkset''' in the MTP3 Network configuration panel | 1- Click '''Create New Mtp3 Linkset''' in the MTP3 Network configuration panel | ||
| Line 10: | Line 13: | ||
* Enter a '''name''' for the linkset | * Enter a '''name''' for the linkset | ||
| − | * Select an ''' | + | * Select an '''origin point code''' (OPC) |
* Select an '''adjacent point code''' | * Select an '''adjacent point code''' | ||
| − | * Make sure the ''' | + | * Make sure the '''desired state''' is set to '''Active''' |
* Click '''Create''' | * Click '''Create''' | ||
[[Image:Toolpack_v2.5_Creating_MTP3_Linkset.png]] | [[Image:Toolpack_v2.5_Creating_MTP3_Linkset.png]] | ||
| − | 3- Verify that the '''Mtp3Linkset was successfully created''' message appears | + | 3- Verify that the '''"Mtp3Linkset was successfully created"''' message appears |
[[Image:Toolpack_v2.5_MTP3_Linkset_Created.png]] | [[Image:Toolpack_v2.5_MTP3_Linkset_Created.png]] | ||
| + | |||
| + | |||
| + | ==List of Parameters== | ||
| + | |||
| + | * [[Parameter: Name|Name]] | ||
| + | * [[Parameter: Origin Point Code|Origin Point Code]] | ||
| + | * [[Parameter: Adjacent Point Code|Adjacent Point Code]] | ||
| + | * [[Parameter: Desired State|Desired State]] | ||
Latest revision as of 10:21, 15 July 2013
Applies to version(s): v2.5, v2.6., v2.7
Now that you have created an MTP3 network, you are ready to create an MTP3 linkset. This can be done through the MTP3 network configuration window. A linkset is used to logically combine multiple MTP3 links going to the same DPC into a single entity. One linkset could be the links between a point code identifying the Tmedia/Tdev SS7 node and a point code identifying the adjacent SS7 equipment.
To create an MTP3 linkset:
1- Click Create New Mtp3 Linkset in the MTP3 Network configuration panel
2- Configure the new linkset:
- Enter a name for the linkset
- Select an origin point code (OPC)
- Select an adjacent point code
- Make sure the desired state is set to Active
- Click Create
3- Verify that the "Mtp3Linkset was successfully created" message appears
