Toolpack:Creating an ISUP Stack A
From TBwiki
(Difference between revisions)
| (4 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
| − | + | === '''''Applies to version(s): v2.5, v2.6.''''' === | |
| + | {{DISPLAYTITLE:Creating an ISUP Stack}} | ||
| + | Now that you have configured the MTP3 layer of your SS7 system, you must create an ISDN user part stack. The ISDN user part (ISUP) is the highest layer in the SS7 signaling stack and is responsible for the handling of calls. | ||
To create an ISUP stack: | To create an ISUP stack: | ||
| + | |||
1- Click '''ISUP''' in the navigation panel | 1- Click '''ISUP''' in the navigation panel | ||
| Line 7: | Line 10: | ||
[[Image:Toolpack_v2.5_Navigation_Panel_ISUP.png]] | [[Image:Toolpack_v2.5_Navigation_Panel_ISUP.png]] | ||
| − | 2- Click '''Create New Stack''' | + | 2- Click '''Create New Stack''' |
[[Image:Toolpack_v2.5_Create_ISUP_Stack.png]] | [[Image:Toolpack_v2.5_Create_ISUP_Stack.png]] | ||
| Line 21: | Line 24: | ||
[[Image:Toolpack_v2.5_Creating_ISUP_Stack.png]] | [[Image:Toolpack_v2.5_Creating_ISUP_Stack.png]] | ||
| − | 4- Verify that the '''IsupStack was successfully created''' message appears | + | 4- Verify that the '''"IsupStack was successfully created"''' message appears |
[[Image:Toolpack_v2.5_ISUP_Stack_Created.png]] | [[Image:Toolpack_v2.5_ISUP_Stack_Created.png]] | ||
| + | |||
| + | |||
| + | ==List of Parameters== | ||
| + | |||
| + | * [[Parameter: Name|Name]] | ||
| + | * [[Parameter: Primary Hardware Adapter|Primary Hardware Adapter]] | ||
| + | * [[Parameter: Secondary Hardware Adapter|Secondary Hardware Adapter]] | ||
Latest revision as of 13:35, 9 July 2012
Applies to version(s): v2.5, v2.6.
Now that you have configured the MTP3 layer of your SS7 system, you must create an ISDN user part stack. The ISDN user part (ISUP) is the highest layer in the SS7 signaling stack and is responsible for the handling of calls.
To create an ISUP stack:
1- Click ISUP in the navigation panel
2- Click Create New Stack
3- Configure the new ISUP stack:
- Make sure the box labeled Enabled is checked
- Enter a name for the stack
- Select a primary hardware adapter
- Select a secondary hardware adapter
- Click Create
4- Verify that the "IsupStack was successfully created" message appears
