Toolpack:Creating an ISUP Interface A
From TBwiki
(Difference between revisions)
(Created page with 'To create an ISUP interface: 1- Click '''Create New Isup Interface''' in the ISUP stack configuration window Image:Toolpack_v2.5_Create_ISUP_Interface.png 2- Configure the…') |
|||
| (6 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
| + | === '''''Applies to version(s): v2.5, v2.6., v2.7''''' === | ||
| + | {{DISPLAYTITLE:Creating an ISUP Interface}} | ||
| + | Now that you have created an [[ISUP]] user part to contain them, you must create new ISUP interfaces. | ||
| + | |||
| + | The [[ISUP]] interface creates a binding within the ISUP layer of a particular variant, a specific network, and an OPC/DPC pair to which circuits can be assigned. | ||
| + | |||
| + | The ISUP interface contains the circuit identifier codes (CICs) within the ISUP user part. One interface is created for each similar grouping of CICs within one user part protocol variant. | ||
| + | |||
To create an ISUP interface: | To create an ISUP interface: | ||
| + | |||
1- Click '''Create New Isup Interface''' in the ISUP stack configuration window | 1- Click '''Create New Isup Interface''' in the ISUP stack configuration window | ||
| Line 17: | Line 26: | ||
[[Image:Toolpack_v2.5_Creating_ISUP_Interface.png]] | [[Image:Toolpack_v2.5_Creating_ISUP_Interface.png]] | ||
| − | 3- Verify that the '''IsupInterface was successfully created''' message appears | + | 3- Verify that the '''"IsupInterface was successfully created"''' message appears |
[[Image:Toolpack_v2.5_ISUP_Interface_Created.png]] | [[Image:Toolpack_v2.5_ISUP_Interface_Created.png]] | ||
| + | |||
| + | |||
| + | ==List of Parameters== | ||
| + | |||
| + | * [[Parameter: Name|Name]] | ||
| + | * [[Parameter: ISUP User Part|ISUP User Part]] | ||
| + | * [[Parameter: ISUP Network|ISUP Network]] | ||
| + | * [[Parameter: Origin Point Code|OPC]] | ||
| + | * [[Parameter: Destination Point Code|DPC]] | ||
Latest revision as of 09:31, 15 July 2013
Applies to version(s): v2.5, v2.6., v2.7
Now that you have created an ISUP user part to contain them, you must create new ISUP interfaces.
The ISUP interface creates a binding within the ISUP layer of a particular variant, a specific network, and an OPC/DPC pair to which circuits can be assigned.
The ISUP interface contains the circuit identifier codes (CICs) within the ISUP user part. One interface is created for each similar grouping of CICs within one user part protocol variant.
To create an ISUP interface:
1- Click Create New Isup Interface in the ISUP stack configuration window
2- Configure the new ISUP interface:
- Enter a name for the interface
- Select an ISUP user part
- Select an ISUP network
- Select a trunk type
- Select an originating point code (OPC)
- Select a destination point code (DPC)
- Click Create
3- Verify that the "IsupInterface was successfully created" message appears
