Toolpack:Creating MTP2 Links A
From TBwiki
(Difference between revisions)
(Created page with 'The MTP2 link is used to connect the MTP2 physical layer to a line service carrying SS7 signaling. To create an MTP2 link: 1- Click '''Create New Mtp2 Link''' in the MTP2 conf…') |
Nicole Tan (Talk | contribs) (NT: Modified the screen shot of the MTP2 Link configuration) |
||
| (6 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
| − | + | === '''''Applies to version(s): v2.5, v2.6., v2.7''''' === | |
| + | {{DISPLAYTITLE:Creating MTP2 Links}} | ||
| + | Now that you have created an MTP2 configuration, you must create the necessary MTP2 links. | ||
| + | An MTP2 link is used to connect the MTP2 physical layer to a line service carrying SS7 signaling. | ||
To create an MTP2 link: | To create an MTP2 link: | ||
| + | |||
1- Click '''Create New Mtp2 Link''' in the MTP2 configuration window | 1- Click '''Create New Mtp2 Link''' in the MTP2 configuration window | ||
| Line 18: | Line 22: | ||
* Click '''Create''' | * Click '''Create''' | ||
| − | [[Image: | + | [[Image:Create_MTP2_Link_2.7.jpg]] |
| − | 3- Verify that the '''MTP2 link was successfully created''' message appears | + | 3- Verify that the '''"MTP2 link was successfully created"''' message appears |
[[Image:Toolpack_v2.5_MTP2_Link_Created.png]] | [[Image:Toolpack_v2.5_MTP2_Link_Created.png]] | ||
| + | |||
| + | |||
| + | ==List of Parameters== | ||
| + | |||
| + | * [[Parameter: Name|Name]] | ||
| + | * [[Parameter: Connection Mode|Connection Mode]] | ||
| + | * [[Parameter: Line Service|Line Service]] | ||
| + | * [[Parameter: Timeslots|Timeslots]] | ||
| + | * [[Parameter: Protocol Type|Protocol Type]] | ||
| + | * [[Parameter: DPC Length|DPC Length]] | ||
| + | * [[Parameter: Timeslot Rate|Timeslot Rate]] | ||
Latest revision as of 10:32, 4 August 2016
Applies to version(s): v2.5, v2.6., v2.7
Now that you have created an MTP2 configuration, you must create the necessary MTP2 links. An MTP2 link is used to connect the MTP2 physical layer to a line service carrying SS7 signaling.
To create an MTP2 link:
1- Click Create New Mtp2 Link in the MTP2 configuration window
2- Configure the new MTP2 link:
- Enter a name for the new link
- Select a connection mode
- Select a line service
- Assign timeslots to the link
- Select a protocol type
- Select a DPC length
- Select a timeslot rate
- Click Create
3- Verify that the "MTP2 link was successfully created" message appears
