Toolpack:Create an SCCP LSAP
From TBwiki
(Difference between revisions)
m |
|||
| (One intermediate revision by one user not shown) | |||
| Line 10: | Line 10: | ||
*The '''Unique identifier MTP3 userpart''' parameter specifies the unique ID of the MTP3 userpart to which this LSAP is connected | *The '''Unique identifier MTP3 userpart''' parameter specifies the unique ID of the MTP3 userpart to which this LSAP is connected | ||
*The '''Maximum message length''' parameter specifies the maximum length of the message delivered to SCCP from this LSAP | *The '''Maximum message length''' parameter specifies the maximum length of the message delivered to SCCP from this LSAP | ||
| − | + | <br> | |
== Further reading == | == Further reading == | ||
[[Toolpack v2.5:Creating an SCCP LSAP|Configuring an SCCP LSAP (Toolpack v2.5)]] | [[Toolpack v2.5:Creating an SCCP LSAP|Configuring an SCCP LSAP (Toolpack v2.5)]] | ||
| − | |||
| − | |||
Latest revision as of 12:13, 1 May 2018
Creating a Lower Service Access Point (LSAP) tells the SCCP protocol layer about a collection of SS7 nodes that are accessible through MTP3.
Description of parameters
General explanation of the configuration parameters:
- The Handle SCCP network parameter specifies the handle of the SCCP network
- The Unique identifier SCCP LSAP parameter specifies the unique ID of the SCCP LSAP for a SS7 system
- The Unique identifier MTP3 userpart parameter specifies the unique ID of the MTP3 userpart to which this LSAP is connected
- The Maximum message length parameter specifies the maximum length of the message delivered to SCCP from this LSAP
