Toolpack:Creating an M3UA SAP A
From TBwiki
(Difference between revisions)
| (4 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
| + | === '''''Applies to version(s): v2.5, v2.6., v2.7''''' === | ||
| + | {{DISPLAYTITLE:Creating an M3UA SAP}} | ||
Now that you have created an M3UA configuration, you must create a new M3UA service access point (SAP) for your system. The SAP is an identifying label for endpoints in your network. | Now that you have created an M3UA configuration, you must create a new M3UA service access point (SAP) for your system. The SAP is an identifying label for endpoints in your network. | ||
| Line 27: | Line 29: | ||
[[Image:Toolpack_v2.5_M3UA_SAP_IP.png]] | [[Image:Toolpack_v2.5_M3UA_SAP_IP.png]] | ||
| + | |||
| + | |||
| + | ==List of Parameters== | ||
| + | |||
| + | * [[Parameter: Name|Name]] | ||
| + | * [[Parameter: SCTP Adapter|SCTP Adapter]] | ||
| + | * [[Parameter: SCTP Source Port|SCTP Source Port]] | ||
Latest revision as of 11:12, 15 July 2013
Applies to version(s): v2.5, v2.6., v2.7
Now that you have created an M3UA configuration, you must create a new M3UA service access point (SAP) for your system. The SAP is an identifying label for endpoints in your network.
To create an M3UA SAP:
1- Click Create New M3ua Sap in the M3UA configuration panel
2- Configure the new SAP:
- Enter a name for the SAP
- Select an SCTP adapter to use
- Select an SCTP source port
- Click Create
3- Verify that the "M3ua Sap was successfully created" message appears
4- Associate an IP interface with the new SAP:
- Select an available IP interface
- Click the"<<" button to associate the interface with the SAP
