Toolpack:Creating an M3UA Network A
From TBwiki
(Difference between revisions)
| (7 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
| + | === '''''Applies to version(s): v2.5, v2.6., v2.7''''' === | ||
| + | {{DISPLAYTITLE:Creating an M3UA Network}} | ||
Now that you have created M3UA SAPs, you must create a new M3UA network to be used with them. | Now that you have created M3UA SAPs, you must create a new M3UA network to be used with them. | ||
| Line 22: | Line 24: | ||
[[Image:Toolpack_v2.5_M3UA_Network_Created.png]] | [[Image:Toolpack_v2.5_M3UA_Network_Created.png]] | ||
| + | |||
| + | |||
| + | ==List of Parameters== | ||
| + | |||
| + | * [[Parameter: Name|Name]] | ||
| + | * [[Parameter: Protocol Type|Protocol Type]] | ||
| + | * [[Parameter: Sub Service Field|Sub-service Field]] | ||
| + | * [[Parameter: DPC Length|DPC Length]] | ||
| + | * [[Parameter: SLS Range|SLS Range]] | ||
Latest revision as of 11:12, 15 July 2013
Applies to version(s): v2.5, v2.6., v2.7
Now that you have created M3UA SAPs, you must create a new M3UA network to be used with them.
To create an M3UA network:
1- Click Create New M3ua Network in the M3UA configuration panel
2- Configure the new M3UA network:
- Enter a name for the network
- Select a protocol type
- Select a sub-service field
- Select a DPC length
- Select an SLS range
- Click Create
3- Verify that the "M3ua Network was successfully created" message appears
