Redundancy & High Availability:Power Supply
From TBwiki
(Difference between revisions)
m (fix image display) |
(rephrase text) |
||
| (One intermediate revision by one user not shown) | |||
| Line 8: | Line 8: | ||
| − | == Redundant Power | + | == Redundant Power Source == |
| + | |||
| + | TelcoBridges recommends to connect the [[Tmedia]] system to 2 independent power sources. This recommendation extends to the system peripheral components like the network switches, for example. | ||
| − | |||
| Line 23: | Line 24: | ||
[[Image:Ha_Power_Entry_Fail.png|Power Distribution Recommended Setup with Primary Source Failure ]] | [[Image:Ha_Power_Entry_Fail.png|Power Distribution Recommended Setup with Primary Source Failure ]] | ||
| + | |||
| + | [[Category:Tmedia_High_Availability|Power Supply]] | ||
Latest revision as of 14:18, 8 February 2011
Redundant Power Supplies
The redundant power supplies is standard for all Tmedia products (optional for TMG800).
This allows the unit to keep running even if the one of them breaks.
It is also worth mentioning that the dual power supplies are hot-swappable. Therefore, a defective power supply can be replaced without shutting down the system.
Redundant Power Source
TelcoBridges recommends to connect the Tmedia system to 2 independent power sources. This recommendation extends to the system peripheral components like the network switches, for example.
Recommended Setup
Here is the schematic of a system with 2 power entry points:
Even if the primary power source fails, the system can still operate, like shown in the following picture.
