|
|
| (6 intermediate revisions by 2 users not shown) |
| Line 1: |
Line 1: |
| − | The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:
| |
| | | | |
| − | *IP Address
| + | ==Management Port== |
| − | *Netmask
| + | |
| − | *Gateway
| + | |
| | | | |
| − | <br/>
| + | [[TMG:Change_Management_IP_Address|Tmedia management port]] |
| − | == To configure a VoIP0 or VoIP1 port ==
| + | |
| | | | |
| − | '''1. Select IP Interfaces from the navigation panel:'''
| + | ==VoIP Port== |
| | | | |
| − | [[Image:Toolpack_v2.5_Navigation_Panel_IP_Interfaces.png]] | + | [[Change_VoIP_Interface_IP_Address|Tmedia VoIP port]] |
| − | | + | |
| − | <br/>
| + | |
| − | '''2. Click 'Edit' from the IP Interfaces Information panel:'''
| + | |
| − | | + | |
| − | [[Image:Toolpack_v2.5_Edit_IP_Interface.png]]
| + | |
| − | | + | |
| − | '''3. Configure the port:'''
| + | |
| − | | + | |
| − | * Indicate whether or not to use DHCP on this port
| + | |
| − | * Enter an IP address
| + | |
| − | * Enter a Netmask
| + | |
| − | * Enter a gateway address
| + | |
| − | * Click '''Save'''
| + | |
| − | | + | |
| − | ''Note: the IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets''
| + | |
| − | <br/>
| + | |
| − | | + | |
| − | [[Image:Toolpack_v2.5_Editing_IP_Interface.png]]
| + | |
| − | <br/>
| + | |
| − | | + | |
| − | '''4. The changes are displayed in the IP interfaces information panel:'''
| + | |
| − | | + | |
| − | [[Image:Toolpack_v2.5_IP_Interface_Edited.png]]
| + | |
| − | <br/>
| + | |
| − | | + | |
| − | '''IMPORTANT!''' The system will display the following notice, describing steps to apply your new configuration:
| + | |
| − | | + | |
| − | [[Image:Toolpack_v2.5_IP_Interface_Alert.png]]
| + | |
