|
|
(2 intermediate revisions by 2 users not shown) |
Line 1: |
Line 1: |
− | The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:
| |
| | | |
− | *IP Address
| + | ==Management Port== |
− | *Netmask
| + | |
− | *Gateway
| + | |
| | | |
− | <br/>
| + | [[TMG:Change_Management_IP_Address|Tmedia management port]] |
− | == To configure a VoIP0 or VoIP1 port ==
| + | |
| | | |
− | 1. Select '''IP Interfaces''' from the navigation panel:
| + | ==VoIP Port== |
| | | |
− | [[Image:Toolpack_v2.5_Navigation_Panel_IP_Interfaces.png]] | + | [[Change_VoIP_Interface_IP_Address|Tmedia VoIP port]] |
− | | + | |
− | <br/>
| + | |
− | 2. Click '''Edit''' from the IP Interfaces Information panel:
| + | |
− | | + | |
− | [[Image:Toolpack_v2.5_Edit_IP_Interface.png]]
| + | |
− | | + | |
− | <br/>
| + | |
− | 3. Configure the IP port:
| + | |
− | | + | |
− | * Indicate whether or not to use '''DHCP''' on this port
| + | |
− | * Enter an '''IP address'''
| + | |
− | * Enter a '''Netmask'''
| + | |
− | * Enter a '''gateway address'''
| + | |
− | * Click '''Save'''
| + | |
− | | + | |
− | '''Note:''' The IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets.
| + | |
− | <br/>
| + | |
− | | + | |
− | [[Image:Toolpack_v2.5_Editing_IP_Interface.png]]
| + | |
− | | + | |
− | <br/>
| + | |
− | | + | |
− | 4. The changes are displayed in the IP interfaces information panel:
| + | |
− | | + | |
− | [[Image:Toolpack_v2.5_IP_Interface_Edited.png]]
| + | |
− | | + | |
− | | + | |
− | '''IMPORTANT!''' The system will display the following notice, describing steps to apply your new configuration:
| + | |
− | | + | |
− | [[Image:Toolpack_v2.5_IP_Interface_Alert.png]]
| + | |
− | | + | |
− | | + | |
− | ==List of Parameters==
| + | |
− | | + | |
− | * [[Parameter: Use DHCP|Use DHCP]]
| + | |
− | * [[Parameter: IP Address|IP Address]]
| + | |
− | * [[Parameter: Netmask|Netmask]]
| + | |
− | * [[Parameter: Gateway|Gateway]]
| + | |