|
|
| Line 3: |
Line 3: |
| | '''Fist version of step 1 second item''' | | '''Fist version of step 1 second item''' |
| | | | |
| − | Now that you have created an initial ISUP stack, you must create a new ISUP network.
| |
| − |
| |
| − | The ISUP network tells the ISUP protocol layer about a collection of SS7 nodes that are accessible through MTP3 or M3UA.
| |
| − | Based upon your system configuration, one or more ISUP networks are created. Repeat this section for as many networks as you require.
| |
| − |
| |
| − |
| |
| − | '''NOTE:''' An ISUP network can be used by multiple ISUP interfaces even if they are members of different ISUP userpart (e.g., to support multiple switch variants for a single SS7 network).
| |
| − |
| |
| − | To create an ISUP network:
| |
| − |
| |
| − |
| |
| − | 1- Click "Create New ISUP Network" in the ISUP stack configuration window
| |
| − |
| |
| − | [[Image:Toolpack_v2.5_Create_ISUP_Network.png]]
| |
| − |
| |
| − | 2- Configure the new ISUP network:
| |
| − |
| |
| − | * Enter a '''name''' for the network
| |
| − | * Select '''MTP3''' or '''M3UA''' as the '''type of network to bind'''
| |
| − | * Select a '''MTP3 network''' or a '''M3UA network'''
| |
| − | * Click '''Create'''
| |
| − |
| |
| − | [[Image:Toolpack_v2.5_Creating_ISUP_Network.png]]
| |
| − |
| |
| − | '''3. Verify that the '''"IsupNetwork was successfully created"''' message appears
| |
| − |
| |
| − | [[Image:Toolpack_v2.5_ISUP_Network_Created.png]]
| |
| − |
| |
| − |
| |
| − | ==List of Parameters==
| |
| − |
| |
| − | * [[Parameter: Name|Name]]
| |
| − | * [[Parameter: Type of Network to Bind|Type of Network to Bind]]
| |
| − | * '''Depending on the type chosen:'''
| |
| − | ** [[Parameter: MTP3 Network|MTP3 Network]]
| |
| − | ** [[Parameter: M3UA Network|M3UA Network]]
| |
| | | | |
| | [[Category:TestCatv2.5]] | | [[Category:TestCatv2.5]] |
| | [[Category:TestCatv2.6]] | | [[Category:TestCatv2.6]] |
