Configure Fax Passthrough A
From TBwiki
(Difference between revisions)
Clod Patry (Talk | contribs) (created this page, print-screen will be added shortly.) |
Clod Patry (Talk | contribs) (Adding screen-shot for passthru using silenceSupp) |
||
| Line 8: | Line 8: | ||
6. Make sure the Codec is the same as the remote end. | 6. Make sure the Codec is the same as the remote end. | ||
</pre> | </pre> | ||
| + | |||
| + | |||
| + | [[Image:profile_passthru_silence_v27.png]] | ||
Revision as of 13:01, 15 June 2012
To enable passthrough, follow these steps:
1. Make sure "Enable Fax/Modem Relay" is enabled. 2. Make sure "Detection Mode" is Standard. 3. Make sure "Relay Mode" is Passthrough. 4. Make sure "Enable switching to FAX relay upon CNG tone" is checked. 5. Make sure "Detection type" is "Silence Suppression off" 6. Make sure the Codec is the same as the remote end.
