Toolpack:Creating an SCCP LSAP A

Revision as of 14:01, 6 June 2012

Applies to version(s): v2.5, v2.6.

Now that you have created an SCCP network, you must create a new SCCP lower service access point (LSAP).

Creating an LSAP tells the SCCP protocol layer about a collection of SS7 nodes that are accessible through MTP3.

To Create an SCCP LSAP:

1- Click Create New SCCP LSAP in the SCCP network configuration window

2- Configure the new SCCP LSAP:

• Enter a Name for the LSAP
• Click Save

3- Verify that the "SccpLsap was successfully created" message appears

4- Next Step: Create an SCCP Route

List of Parameters

• Name

Navigation