Configure Fax Passthrough NSE A
From TBwiki
(Difference between revisions)
Clod Patry (Talk | contribs) (remove the condition with CNG for NSE) |
Clod Patry (Talk | contribs) (Adding the screen-shot) |
||
| Line 8: | Line 8: | ||
6. Make sure "Use NSE" is checked. By unchecking this option, you will switch to Fax Passthrough using SIP re-INVITE. | 6. Make sure "Use NSE" is checked. By unchecking this option, you will switch to Fax Passthrough using SIP re-INVITE. | ||
</pre> | </pre> | ||
| + | |||
| + | |||
| + | [[Image:profile_nse_v27.png]] | ||
Revision as of 12:53, 15 June 2012
To enable passthrough with NSE, follow these steps:
1. Make sure "Enable Fax/Modem Relay" is enabled. 2. Make sure "Detection Mode" is Standard. 3. Make sure "Relay Mode" is Passthrough. 4. Make sure "Detection type" is "Silence Suppression off" 5. Make sure the Codec is the same as the remote end. 6. Make sure "Use NSE" is checked. By unchecking this option, you will switch to Fax Passthrough using SIP re-INVITE.
