Toolpack:Enabling Transit Network Selection A
From TBwiki
(Difference between revisions)
(First version of the page to enable transit network selection) |
(Changed title of section for Route column) |
||
| Line 11: | Line 11: | ||
'''To properly configure transit network selection, do the following:''' | '''To properly configure transit network selection, do the following:''' | ||
*[[Toolpack:Modifying_Transit_Network_Selection_Filters_A|Modify Transit Network Selection filters to suit your needs]] | *[[Toolpack:Modifying_Transit_Network_Selection_Filters_A|Modify Transit Network Selection filters to suit your needs]] | ||
| − | *[[Toolpack: | + | *[[Toolpack:Adding_Network_Identification_Column_To_Routes_A|Add Network Identification column to Routes]] |
*[[Toolpack:Adding_Transit_Network_Selection_To_Routing_Script_A|Add Transit Network Selection to your Routing Script]] | *[[Toolpack:Adding_Transit_Network_Selection_To_Routing_Script_A|Add Transit Network Selection to your Routing Script]] | ||
Revision as of 15:43, 13 December 2012
Applies to version(s): v2.6, v2.7.
Information for carrier selection can be included in the set-up information of a call, in the Transit Network Selection (TNS) parameter. If present, this information is used to route the call to an exchange giving access to the network of this carrier.
Note : For SPIROU, this information is conveyed either in the TNS parameter or in the called party number.
To properly configure transit network selection, do the following:
