Toolpack:Modifying ISUP Userpart for SPIROU A
From TBwiki
(Difference between revisions)
(Added configuration of T6 timer) |
(Added list of Parameters) |
||
| Line 14: | Line 14: | ||
5- A new checkbox '''Strict SPIROU validation''' appears once SPIROU Protocol Variant is selected. | 5- A new checkbox '''Strict SPIROU validation''' appears once SPIROU Protocol Variant is selected. | ||
| − | * | + | *Check this new checkbox to make sure your configuraton is compliant with SPIROU. |
| − | + | ||
6- Click '''Timers''' to expand the Timers section | 6- Click '''Timers''' to expand the Timers section | ||
| Line 23: | Line 23: | ||
9- Verify that the '''"IsupUserpart was successfully updated"''' message is displayed | 9- Verify that the '''"IsupUserpart was successfully updated"''' message is displayed | ||
| + | |||
| + | ==List of Parameters== | ||
| + | |||
| + | * [[Parameter: Protocol Type|Protocol Variant]] | ||
| + | * [[Toolpack:Enabling_strict_SPIROU_validation A|Strict SPIROU validation]] | ||
| + | * [[Parameter: Isup Userpart Timers|Timers]] | ||
Revision as of 14:48, 14 December 2012
Applies to version(s): v2.6, v2.7.
This section assumes:
- SS7 ISUP is already configured
1- Select SS7-->ISUP from the navigation panel
2- Click on the Edit button for the ISUP stack you want to configure
3- In the Editing Userparts section, click on the ISUP userpart you want to configure
4- Select SPIROU in the Protocol Variant drop-down menu
5- A new checkbox Strict SPIROU validation appears once SPIROU Protocol Variant is selected.
- Check this new checkbox to make sure your configuraton is compliant with SPIROU.
6- Click Timers to expand the Timers section
7- Set T6 Timer between 60000 and 120000 ms (between 60 and 120 seconds)
8- Click the Save button
9- Verify that the "IsupUserpart was successfully updated" message is displayed
