Toolpack v2.7: clearmode configuration
Clod Patry (Talk | contribs) (adding when ptime is not specify, this means 20ms.) |
(→Applies to version(s): v2.7.) |
||
| Line 1: | Line 1: | ||
| − | === '''''Applies to version(s): v2.7 | + | === '''''Applies to version(s): v2.7 and above''''' === |
{{DISPLAYTITLE:Configure ClearMode}} | {{DISPLAYTITLE:Configure ClearMode}} | ||
Clearmode is defined in RFC4040 and is fully supported and does not required any special licensing or configuration from the Web portal to enable it. | Clearmode is defined in RFC4040 and is fully supported and does not required any special licensing or configuration from the Web portal to enable it. | ||
| − | |||
== For ISDN/SS7 to SIP calls == | == For ISDN/SS7 to SIP calls == | ||
Revision as of 09:44, 23 March 2017
Contents |
Applies to version(s): v2.7 and above
Clearmode is defined in RFC4040 and is fully supported and does not required any special licensing or configuration from the Web portal to enable it.
For ISDN/SS7 to SIP calls
If the SETUP/IAM message have its Information Transfer Rate and Information Transfer Capability set to 64kbits/sec Unrestricted, the Codec will be force to Clear Channel on the SIP side.
This will result in:
m=audio 0 RTP/AVP 96
a=rtpmap:96 CLEARMODE/8000
By not specifying the ptime, this means it's 20ms.
If you want to use a packetization time different from 20ms, you have to go Profile->RTP and Audio->Clear Channel.
And this will result in a SDP like:
m=audio 0 RTP/AVP 96
a=rtpmap:96 CLEARMODE/8000
a=ptime:10
For SIP to ISDN/SS7 calls
In the INVITE message, if the SDP is received with Clear Channel SDP (CLEARMODE/8000), the SETUP/IAM ISDN/SS7 Information Transfer Rate and Information Transfer Capability will be set accordingly (64kbits/sec Unrestricted).
Note: The use of Clear Channel is equivalent to the cost of G.711 codec density.
