Toolpack:Creating MTP2 Links B
From TBwiki
(Difference between revisions)
m |
|||
| Line 8: | Line 8: | ||
1- Click '''MTP2''' in the Navigation panel. | 1- Click '''MTP2''' in the Navigation panel. | ||
| − | [[Image: | + | [[Image:Mtp2_0_A.png]] |
2- Click '''Create New Mtp2 Link''' in the MTP2 configuration window | 2- Click '''Create New Mtp2 Link''' in the MTP2 configuration window | ||
Revision as of 08:30, 9 September 2014
Applies to version(s): v2.8
Once you have created an MTP2 configuration, you must create the necessary MTP2 links. An MTP2 link is used to connect the MTP2 physical layer to a line service carrying SS7 signaling.
To create an MTP2 link:
1- Click MTP2 in the Navigation panel.
2- Click Create New Mtp2 Link in the MTP2 configuration window
3- Configure the new MTP2 link:
- Enter a name for the new link
- Select a connection mode
- Select a line service
- Assign timeslots to the link
- Select a protocol type
- Select a DPC length
- Select a timeslot rate
- Click Create
4- Verify that the "MTP2 link was successfully created" message appears
