Toolpack:Creating the M2PA Configuration c
From TBwiki
(Difference between revisions)
(→Applies to version(s): v2.8.) |
(→Applies to version(s): v2.8.) |
||
| Line 1: | Line 1: | ||
=== '''''Applies to version(s): v2.8.''''' === | === '''''Applies to version(s): v2.8.''''' === | ||
{{DISPLAYTITLE:Creating the M2PA Configuration}} | {{DISPLAYTITLE:Creating the M2PA Configuration}} | ||
| − | + | ||
To create your system's M2PA configuration: | To create your system's M2PA configuration: | ||
Revision as of 09:42, 18 September 2014
Applies to version(s): v2.8.
To create your system's M2PA configuration:
1- Select M2PA from the navigation panel
2- Configure the M2PA service
- Make sure the box labelled Enabled is checked
- Enter a name for the M2PA service
- Click Create
3- Verify that the "M2pa Cfg was successfully created" message appears
