Toolpack:Creating an SCCP LSAP B
From TBwiki
(Difference between revisions)
| Line 28: | Line 28: | ||
* Enter a [[Parameter: Name|Name]] for the LSAP | * Enter a [[Parameter: Name|Name]] for the LSAP | ||
| − | * Click ''' | + | * Click '''Create''' |
[[Image:Create_SCCP_LSAP_1.png]] | [[Image:Create_SCCP_LSAP_1.png]] | ||
Revision as of 12:22, 26 September 2014
Applies to version(s): v2.8
After you create an SCCP network, you must create a new SCCP lower service access point (LSAP).
Creating an LSAP tells the SCCP protocol layer about a collection of SS7 nodes that are accessible through MTP3.
To Create an SCCP LSAP:
1- Select SCCP from the navigation panel
2- Select an SCCP Network
3- Click Create New SCCP LSAP in the SCCP network configuration window
4- Configure the new SCCP LSAP:
- Enter a Name for the LSAP
- Click Create
5- Verify that the "SccpLsap was successfully created" message appears
