Toolpack:Creating an SCCP Route B
From TBwiki
(Difference between revisions)
(New 2.8 artilce) |
(New 2.8 article) |
||
| Line 7: | Line 7: | ||
| − | - Select '''SCCP''' from the navigation panel | + | 1- Select '''SCCP''' from the navigation panel |
| Line 19: | Line 19: | ||
| − | 3- | + | 3- Select an SCCP LSAP |
| − | |||
| + | [[Image:Select_SCCP_LSAP_0.png]] | ||
| − | 4- Configure the new SCCP Route: | + | |
| + | 4- Click '''Create new Sccp Route''' in the SCCP LSAP configuration window | ||
| + | |||
| + | [[Image:Create_SCCP_Route_0.png]] | ||
| + | |||
| + | |||
| + | 5- Configure the new SCCP Route: | ||
* Choose a [[Parameter: Name|Name]] for the new route | * Choose a [[Parameter: Name|Name]] for the new route | ||
| Line 33: | Line 39: | ||
* Click '''Create''' | * Click '''Create''' | ||
| − | [[Image: | + | [[Image:Create_SCCP_Route_1.png]] |
| − | + | 6- Verify that the '''"SccpRoute was successfully created"''' message appears | |
| − | [[Image: | + | [[Image:Create_SCCP_Route_2.png]] |
| − | + | 7- Configure [[SCCP Route Backup Point Code]] | |
* Assign [[Parameter: SCCP Backup Point Code| Backup Point Codes]] to use in case this route's [[DPC]] is not available. | * Assign [[Parameter: SCCP Backup Point Code| Backup Point Codes]] to use in case this route's [[DPC]] is not available. | ||
| − | [[Image: | + | |
| + | [[Image:Create_SCCP_Route_3.png]] | ||
* '''Note: For each selected point codes, a valid SCCP route must be exist'''. | * '''Note: For each selected point codes, a valid SCCP route must be exist'''. | ||
Revision as of 12:33, 26 September 2014
Applies to version(s): v2.8
Now that you have created an SCCP LSAP, you must create a new SCCP route for your system. This step in the Web Portal configuration exists to create a route to a specific destination point code (DPC).
To Create an SCCP Route:
1- Select SCCP from the navigation panel
2- Select an SCCP Network
3- Select an SCCP LSAP
4- Click Create new Sccp Route in the SCCP LSAP configuration window
5- Configure the new SCCP Route:
- Choose a Name for the new route
- Select a Protocol Variant
- Select a Replication Mode (ANSI96 and TELCORDIA variants)
- Select an SLS Mask (ANSI and TELCORDIA protocol variants)
- Select a Destination Point Code for this route
- Click Create
6- Verify that the "SccpRoute was successfully created" message appears
7- Configure SCCP Route Backup Point Code
- Assign Backup Point Codes to use in case this route's DPC is not available.
- Note: For each selected point codes, a valid SCCP route must be exist.
List of Parameters
- Name
- Protocol Variant
- Replication Mode
- SLS Mask (For ANSI and TELCORDIA variants only)
- Destination Point Code
