Toolpack:Creating an SCCP Route B

Latest revision as of 14:02, 30 September 2015

Applies to version(s): v2.8

Now that you have created an SCCP LSAP, you must create a new SCCP route for your system. This step in the Web Portal configuration exists to create a route to a specific destination point code (DPC).

To Create an SCCP Route:

1- Select SCCP from the navigation panel

2- Select an SCCP Network

3- Select an SCCP LSAP

4- Click Create new Sccp Route in the SCCP LSAP configuration window

5- Configure the new SCCP Route:

• Choose a Name for the new route
• Select a Protocol Variant
• Select a Replication Mode (ANSI96 and TELCORDIA variants)
• Select an SLS Mask (ANSI and TELCORDIA protocol variants)
• Select a Destination Point Code for this route
• Click Create

6- Verify that the "SccpRoute was successfully created" message appears

7- Configure SCCP Route Backup Point Code

• Assign Backup Point Codes to use in case this route's DPC is not available.

• Note: For each selected point codes, a valid SCCP route must exist.

List of Parameters

• Name
• Protocol Variant
• Replication Mode
• SLS Mask (For ANSI and TELCORDIA variants only)
• Destination Point Code

Advanced Parameters

• Broadband Support