Modify Fax Relay Profile C
From TBwiki
(Difference between revisions)
(→List of Parameters) |
|||
| Line 34: | Line 34: | ||
* [[Parameter: Fax Modem Relay: Enable early Fax/Modem tone detection|Fax Modem Relay: Enable early Fax/Modem tone detection]] | * [[Parameter: Fax Modem Relay: Enable early Fax/Modem tone detection|Fax Modem Relay: Enable early Fax/Modem tone detection]] | ||
* [[Parameter: Fax Modem Relay: Enable switching to FAX relay upon CNG tone|Fax Modem Relay: Enable switching to FAX relay upon CNG tone]] | * [[Parameter: Fax Modem Relay: Enable switching to FAX relay upon CNG tone|Fax Modem Relay: Enable switching to FAX relay upon CNG tone]] | ||
| + | * [[Parameter: Fax Modem Relay: Switch to passthrough upon Bell ANS|Fax Modem Relay: Switch to passthrough upon Bell ANS]] | ||
<br> | <br> | ||
T.38 Parameters | T.38 Parameters | ||
| Line 47: | Line 48: | ||
* [[Parameter: Fax Modem Pass-Through Parameters: Jitter Buffer Depth| Fax Modem Pass-Through Parameters: Jitter Buffer Depth]] | * [[Parameter: Fax Modem Pass-Through Parameters: Jitter Buffer Depth| Fax Modem Pass-Through Parameters: Jitter Buffer Depth]] | ||
* [[Parameter: Fax Modem Pass-Through Parameters: Use NSE| Fax Modem Pass-Through Parameters: Use NSE]] | * [[Parameter: Fax Modem Pass-Through Parameters: Use NSE| Fax Modem Pass-Through Parameters: Use NSE]] | ||
| + | * [[Parameter: Fax Modem Pass-Through Parameters: Support V.152 VBD| Fax Modem Pass-Through Parameters: Support V.152 VBD]] | ||
| + | * [[Parameter: Fax Modem Pass-Through Parameters: Force V.152 VBD| Fax Modem Pass-Through Parameters: Force V.152 VBD]] | ||
Revision as of 10:34, 6 November 2014
Applies to version v2.8
To configure FAX Relay settings, do the following:
1- Click Fax Relay in the Editing Profile window, to display the customizable options.
2- Modify settings as required.
3- To configure NSE, check the Use NSE checkbox.
NOTE:
If NSE exchange is possible (negociated in the SDP), the switch to passthrough will happen in the RTP stream and no longer wiil occur with a SIP re-INVITE. This implementation of NSE currently only supports a switch to passthrough, which means that you can have NSE packets switching to T.38.
- Click Save
List of Parameters
Fax/Modem Relay
- Fax Modem Relay:Enable Fax/Modem Relay
- Fax Modem Relay: Detection Mode
- Fax Modem Relay: Relay Mode
- Fax Modem Relay: Modem vs. Fax distinction timeout
- Fax Modem Relay: Fax/Modem tones detection duration
- Fax Modem Relay: Enable early Fax/Modem tone detection
- Fax Modem Relay: Enable switching to FAX relay upon CNG tone
- Fax Modem Relay: Switch to passthrough upon Bell ANS
T.38 Parameters
- T.38 Parameters: Use V.34
- T.38 Parameters: Maximum Bit Rate
- T.38 Parameters: Fill Bit Removal
- T.38 Parameters: Redundancy Count
- T.38 Parameters: Transmission level (-1dBm unit)
Fax/Modem Pass-through Parameters
