Toolpack:Reset HostRole A
From TBwiki
(Difference between revisions)
(Created page with "=== '''''Applies to version v2.8''''' === {{DISPLAYTITLE:Resetting the Host Role}} If you need to change the internal IP addresses of a gateway, you must reset the units' hos...") |
(Reset host role article) |
||
| Line 7: | Line 7: | ||
| − | 1- | + | 1- Select '''Hosts''' from the navigation panel. |
[[Image:HostRoleReset_0_A.png]] | [[Image:HostRoleReset_0_A.png]] | ||
| − | 2- Select | + | 2- Select the serial number of the unit. |
[[Image:HostRoleReset_1_A.png]] | [[Image:HostRoleReset_1_A.png]] | ||
| − | 3- | + | 3- Click the '''Status''' tab. |
| − | + | ||
[[Image:HostRoleReset_2_A.png]] | [[Image:HostRoleReset_2_A.png]] | ||
| − | + | 4- Select '''Reset Host Role''' | |
| − | + | * Click '''Apply Action''' | |
[[Image:HostRoleReset_3_A.png]] | [[Image:HostRoleReset_3_A.png]] | ||
| − | + | 5- The Web Portal Unit Role Selection page is displayed. (You may need to refresh your web page to see this) | |
| − | + | ||
[[Image:HostRoleReset_4_A.png]] | [[Image:HostRoleReset_4_A.png]] | ||
Revision as of 12:27, 2 February 2015
Applies to version v2.8
If you need to change the internal IP addresses of a gateway, you must reset the units' host role settings.
To reset the host role, do the following:
1- Select Hosts from the navigation panel.
2- Select the serial number of the unit.
3- Click the Status tab.
4- Select Reset Host Role
- Click Apply Action
5- The Web Portal Unit Role Selection page is displayed. (You may need to refresh your web page to see this)
