Toolpack:Creating an M3UA SAP (IPSP) B

Revision as of 13:09, 23 June 2015

Applies to version(s): v2.8

Once an M3UA configuration is created, you must then create a new M3UA service access point (SAP) for your system. The SAP is an identifying label for endpoints in your network.

To create an M3UA SAP:

1- Click M3UA in the navigation panel:

2- Click Create New M3ua Sap in the M3UA configuration panel

3- Configure the new SAP:

• Enter a name for the SAP
• Select an Unit to use
• Select an SCTP source port
• Click Create

4- Verify that the "M3ua Sap was successfully created" message appears

5- Associate an IP interface with the new SAP:

• Select an available IP interface
• Click the"<<" button to associate the interface with the SAP

List of Parameters

• Name
• SCTP Adapter
• SCTP Source Port