Toolpack:Creating MTP2 Links B
From TBwiki
(Difference between revisions)
(→List of Parameters) |
(→List of Parameters) |
||
| Line 47: | Line 47: | ||
* [[Parameter: Timeslot Rate|Timeslot Rate]] | * [[Parameter: Timeslot Rate|Timeslot Rate]] | ||
* [[Parameter: Error Correction|Error Correction]] | * [[Parameter: Error Correction|Error Correction]] | ||
| − | + | <br> | |
<div class="mw-collapsible mw-collapsed" data-collapsetext="Timers" data-expandtext="Timers" style="width: 400px;"> | <div class="mw-collapsible mw-collapsed" data-collapsetext="Timers" data-expandtext="Timers" style="width: 400px;"> | ||
{| class="wikitable" | {| class="wikitable" | ||
Revision as of 11:32, 1 September 2015
Applies to version(s): v2.8
Once you have created an MTP2 configuration, you must create the necessary MTP2 links. An MTP2 link is used to connect the MTP2 physical layer to a line service carrying SS7 signaling.
To create an MTP2 link:
1- Click MTP2 in the navigation panel.
2- Click Create New Mtp2 Link in the MTP2 configuration window
3- Configure the new MTP2 link:
- Enter a name for the new link
- Select a connection mode
- Select a line service
- Assign timeslots to the link
- Select a protocol type
- Select a DPC length
- Select a timeslot rate
- Select the type of Error Correction to use.
- Click Create
4- Verify that the "MTP2 link was successfully created" message appears
List of Parameters
Lives States
