Toolpack:Modifying ISUP Userpart for SPIROU B
From TBwiki
(Difference between revisions)
(→List of Parameters) |
(→List of Parameters) |
||
| Line 48: | Line 48: | ||
==List of Parameters== | ==List of Parameters== | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
* [[Parameter: Name|Name]] | * [[Parameter: Name|Name]] | ||
Revision as of 13:07, 30 September 2015
Applies to version(s): v2.8.
This article assumes that SS7 ISUP is configured'.
1- Select ISUP from the navigation panel
2- Select the ISUP stack you wishto configure.
3- In the Editing Userparts section, select the ISUP userpart you to configure.
4- Select SPIROU in the Protocol Variant drop-down menu.
5- A new checkbox Strict SPIROU validation appears once SPIROU Protocol Variant is selected.
- Select this checkbox to make sure your configuraton is compliant with SPIROU.
6- Click Timers to expand the Timers section
- Set T6 Timer to a value between 60000 and 120000 ms (between 60 and 120 seconds)
7- Click Advanced Parameters to expand the Advanced Parameters section
- Uncheck the Allow group messages option
- Click Save
8- Verify that the "IsupUserpart was successfully updated" message is displayed
List of Parameters
- Name
- Protocol Variant
- MTP3 Sub Service field
- Default Nature of Address When Unspecified
- Default Numbering Plan When Unspecified
