Toolpack:Creating a 1+1 Group C
From TBwiki
(Difference between revisions)
(Created page with "=== '''''Applies to version v2.9''''' === {{DISPLAYTITLE:Creating a 1+1 Group}} A 1+1 group indentifies the two Tmedia hardware devices that operate together to provide 1+1 b...") |
(→Applies to version v2.9) |
||
| Line 30: | Line 30: | ||
[[Image:Create1and1Group_3_B.png]] | [[Image:Create1and1Group_3_B.png]] | ||
| − | + | ||
<div class="mw-collapsible mw-collapsed" data-collapsetext="Northbound Interface" data-expandtext="Northbound Interface" style="width: 400px;"> | <div class="mw-collapsible mw-collapsed" data-collapsetext="Northbound Interface" data-expandtext="Northbound Interface" style="width: 400px;"> | ||
| Line 41: | Line 41: | ||
<pre> | <pre> | ||
</pre> | </pre> | ||
| + | |||
'''Parameters (json)''' | '''Parameters (json)''' | ||
Revision as of 11:06, 30 October 2015
Applies to version v2.9
A 1+1 group indentifies the two Tmedia hardware devices that operate together to provide 1+1 backup protection. One device is identified as the primary hardware device, while the other device is identified as the backup hardware device. To create a 1+1 group, you must use the Tmedia Web Portal.
To create a 1+1 group:
1- Click 1+1 in the navigation panel
2- Click Create New 1+1 Group
3- Enter the serial numbers of the primary and 1+1 backup hardware devices.
- Provide a name for the 1+1 group.
- Select the serial number of the primary hardware device. (This field may already be filled.)
- Select the serial number of the 1+1 backup hardware device.
- Set Auto switch-back to cause an automatic switch back to the original primary hardware device when it becomes available. If the field is clear (not checked), then a switch back to the original device will occur only after a manual reboot of the system.
- Click Create
4- Verify that the newly added 1+1 group appears in the 1+1 Groups list.
Path
Parameters (text)
Parameters (json)
