Toolpack:Create OC3 STM1 Configuration A

Revision as of 14:13, 5 April 2016

Applies to version(s): v2.9.

The STM1 and OC3 line interfaces can be configured to suit many needs, as shown in the STM1 and OC3 Configuration overview images. Each configuration begins with the creation of a line interface followed by a paraernt line service that is followed by one or more child line services. Depending on the line service that you create the payload must agree.

STM1 Configuration Overview

OC3 Configuration Overview

Configuration Example 1: STM1->1x VC4->63x VC12->1x E1

• In this configuration, create one STM1 line interface. Then create one VC4 line service for the STM1 line interface. To the VC4 line service create up to 63 VC12 line services. Finally, to each VC12 line service assign one E1 line service.

Configuration Example 2: STM1->3x VC3->21x VC12->1x E1

• In this configuration, create one STM1 line interface. Then create three VC3 line services for the STM1 line interface. For each VC3 line service create up to 21 VC12 line services. Finally, to each VC12 line service assign one E1 line service.

Configuration Example 3: OC3->3x STS3->28x VT1.5->1x T1

In this configuration, create one OC3 line interface. Then create up to three STS1 line services for the OC3 line interface. To each STS1 line service create up to 28 VT1.5 line services. Finally, to each VC12 line service assign one T1 line service.