Use Cases:TMG Performing M2UA Signaling Relay
From TBwiki
(Difference between revisions)
Nicole Tan (Talk | contribs) |
(Added link to Configuration page) |
||
| Line 31: | Line 31: | ||
**No need to configure MTP3 part | **No need to configure MTP3 part | ||
|} | |} | ||
| + | |||
| + | == References == | ||
| + | *[[Toolpack:Protocol_Stack_Settings_B#M2UA.3C-.3EMTP2_Relay|Configuring MTP2 to M2UA relay]] | ||
Revision as of 13:26, 30 September 2016
Editing Use Cases:TMG Performing M2UA Signaling Relay WikitextPreviewChanges BoldItalicEmbedded fileSignature and timestampLinkReferenceAdvancedSpecial charactersHelp
Applies to version(s): v2.9 and above
In this scenario, all messages from TDM network are relayed to the IP network via Sigtran: M2UA
Note: This implementation, although based on standards, is proprietary.
Normally, one end is the SG and the other is the MGC.
So in this use case, one of the TMGs simulates the MGC. All of this is transparent to the TDM devices interconnected over IP.
| Configure TMG: M2UA Relay | Configure TMG: M2UA SG |
|---|---|
|
|
