Toolpack:Creating a SIP Stack SBC A
From TBwiki
(Difference between revisions)
(→List of Parameters) |
(Added image of SIP navigation menu selection) |
||
| Line 8: | Line 8: | ||
1- Click '''SIP''' in the navigation panel | 1- Click '''SIP''' in the navigation panel | ||
| − | + | [[Image:SIP_NavigationMenu.png]] | |
| Line 29: | Line 29: | ||
Allyn: Screenshot here | Allyn: Screenshot here | ||
| − | |||
==List of Parameters== | ==List of Parameters== | ||
Revision as of 14:52, 5 May 2017
Applies to version(s): v3.0
Session Initiation Protocol, more commonly known as SIP, is a signaling protocol for packet-based networks and is commonly used, along with H.323 to provide signaling for Voice over IP (VoIP) communications. You must configure SIP signaling for your system. The first step in doing so is to create a SIP stack:
1- Click SIP in the navigation panel
2- Click Create New Sip
Allyn: Screenshot here Allyn: For the screenshot make sure you have selected "HOST" in the Unit drop box.
3- Create the new SIP stack:
- Verify that the box labeled Enabled is checked
- Enter a name for the stack
- Click Create
Allyn: Screenshot here
4- Verify that the "SipCfg was successfully created" message appears
Allyn: Screenshot here
List of Parameters
Advanced
