Toolpack:Creating a SIP Domain SBC A
From TBwiki
(Difference between revisions)
(add missing parameter) |
(add missing parameters) |
||
| Line 22: | Line 22: | ||
* Set the number 'Maximum Registered Users' for this domain | * Set the number 'Maximum Registered Users' for this domain | ||
* Set the Expires value used by SBC when the remote device doesn't supply one ('''Default Contact Expire''') | * Set the Expires value used by SBC when the remote device doesn't supply one ('''Default Contact Expire''') | ||
| − | * Select '''Routing Method''' | + | * Select '''Routing Method''' the system will use to route sessions. |
| − | ** '''Register source''': | + | ** '''Register source''': Sends SIP Invite to the registering source IP address. |
| − | ** '''Contact''': | + | ** '''Contact''': Sends SIP Invite to the 'contact' from the Register message. |
| + | * '''Forwarding Mode''' | ||
| + | ** '''Contact Remapping''': Changes the user and the IP address. | ||
| + | ** '''Contact Passthrough''': Doesn't change anything. Enables devices to be contacted directly without going through the SBC. | ||
* Click '''Create''' | * Click '''Create''' | ||
Revision as of 12:09, 10 May 2017
Applies to version(s): v3.0
A SIP domain represents a grouping of devices (or users) that can communicate with one another. You must configure SIP Registration Domain for your system. The first step in doing so is to create a SIP Domain:
1- Click SIP Domain in the navigation panel
2- Click Create New Domain
3- Create the new Domain:
- Enter a Name of this configuration
- Enter a Domain Name for the SIP Registration Domain (domain can be a FQDN or an IP address)
- Set the number 'Maximum Registered Users' for this domain
- Set the Expires value used by SBC when the remote device doesn't supply one (Default Contact Expire)
- Select Routing Method the system will use to route sessions.
- Register source: Sends SIP Invite to the registering source IP address.
- Contact: Sends SIP Invite to the 'contact' from the Register message.
- Forwarding Mode
- Contact Remapping: Changes the user and the IP address.
- Contact Passthrough: Doesn't change anything. Enables devices to be contacted directly without going through the SBC.
- Click Create
4- Verify that the Sip registration domain was successfully created message appears
