Toolpack:Creating a SIP Domain SBC A

Revision as of 15:00, 26 July 2017

Applies to version(s): v3.0

A SIP domain represents a grouping of devices (or users) that can communicate with one another. You must configure SIP Registration Domain for your system. The first step in doing so is to create a SIP Domain:

1- Click SIP Domain in the navigation panel

2- Click Create New Domain

3- Create the new Domain:

• Enter a configuration Name for this domain.
• Enter a Domain Name for the SIP Registration Domain (domain can be a FQDN or an IP address)
• Set the number 'Maximum Registered Users' for this domain
• Set the Expires value used by SBC when the remote device doesn't supply one (Default Contact Expire)
• Select Routing Method the system will use to route calls to registered users (if enabled in routing scripts).
  • Register source: Sends SIP Invite to the registering source IP address.
  • Contact: Sends SIP Invite to the 'contact' from the Register message.
• Forwarding Mode
  • Contact Remapping: Changes the user and the IP address.
  • Contact Passthrough: Doesn't change anything. Enables devices to be contacted directly without going through the SBC.
• Click Create

4- Verify that the Sip registration domain was successfully created message appears