Toolpack:Creating a SIP Domain SBC A
From TBwiki
(Difference between revisions)
| Line 25: | Line 25: | ||
** '''Register source''': Sends SIP Invite to the registering source IP address. | ** '''Register source''': Sends SIP Invite to the registering source IP address. | ||
** '''Contact''': Sends SIP Invite to the 'contact' from the Register message. | ** '''Contact''': Sends SIP Invite to the 'contact' from the Register message. | ||
| − | * '''Forwarding Mode''' | + | * '''Default Contact Expiration''': Default 'Expires' value when not supplied by the user agent. |
| − | ** '''Contact Remapping''': Changes the user and the IP address. | + | * '''Minimum Contact Expiration''': Minimum 'Expires' value accepted. Lower values will be rejected with a 423 'Interval too brief' response. |
| − | ** '''Contact Passthrough''': Doesn't change anything. Enables devices to be contacted directly without going through the SBC. | + | * '''Maximum Contact Expiration''': Maximum 'Expires' value accepted. Higher value are replaced by this parameter. |
| + | * '''Forwarding Parameters''': | ||
| + | ** '''Forwarding Mode''': | ||
| + | *** '''Contact Remapping''': Changes the user and the IP address. | ||
| + | *** '''Contact Passthrough''': Doesn't change anything. Enables devices to be contacted directly without going through the SBC. | ||
| + | ** '''Minimum Registrar Expiration''': Minimum 'Expires' value sent to the registrar. | ||
| + | ** '''Maximum Pending Register Forward''': Maximum simultaneous pending register requests allowed for this domain. | ||
| + | ** '''Maximum Simultaneous Register Forward''': Maximum simultaneous active register requests allowed for this domain. | ||
* Click '''Create''' | * Click '''Create''' | ||
Revision as of 15:09, 26 July 2017
Applies to version(s): v3.0
A SIP domain represents a grouping of devices (or users) that can communicate with one another. You must configure SIP Registration Domain for your system. The first step in doing so is to create a SIP Domain:
1- Click SIP Domain in the navigation panel
2- Click Create New Domain
3- Create the new Domain:
- Enter a configuration Name for this domain.
- Enter a Domain Name for the SIP Registration Domain (domain can be a FQDN or an IP address)
- Set the number 'Maximum Registered Users' for this domain
- Set the Expires value used by SBC when the remote device doesn't supply one (Default Contact Expire)
- Select Routing Method the system will use to route calls to registered users (if enabled in routing scripts).
- Register source: Sends SIP Invite to the registering source IP address.
- Contact: Sends SIP Invite to the 'contact' from the Register message.
- Default Contact Expiration: Default 'Expires' value when not supplied by the user agent.
- Minimum Contact Expiration: Minimum 'Expires' value accepted. Lower values will be rejected with a 423 'Interval too brief' response.
- Maximum Contact Expiration: Maximum 'Expires' value accepted. Higher value are replaced by this parameter.
- Forwarding Parameters:
- Forwarding Mode:
- Contact Remapping: Changes the user and the IP address.
- Contact Passthrough: Doesn't change anything. Enables devices to be contacted directly without going through the SBC.
- Minimum Registrar Expiration: Minimum 'Expires' value sent to the registrar.
- Maximum Pending Register Forward: Maximum simultaneous pending register requests allowed for this domain.
- Maximum Simultaneous Register Forward: Maximum simultaneous active register requests allowed for this domain.
- Forwarding Mode:
- Click Create
4- Verify that the Sip registration domain was successfully created message appears
