Toolpack:Adding a Transcoding Unit A

From TBwiki

(Difference between revisions)

Revision as of 11:58, 24 October 2017

To add a transcoding unit:

1- Click Hardware Units in the navigation panel

2- Click Create New Unit, to add a new hardware device

3- Enter information for the following parameters:

Enter a name for the hardware device
Enter the serial number of the new hardware device (filling in the Serial Number field will cause auto-completion of the field to occur).
Select TDM and/or IP from the Type field.
Enter the location in which the hardware device is installed.
Enter a meaningful description about the use or purpose of the hardware device.
Select Enabled from the Target State field.
Select the type of TDM lines that the hardware device will support.
Leave the Is N+1 Backup field empty.
Provide the amount of time in seconds, that the system will wait for calls to complete before shutting down for an upgrade.
Click Create

4- Verify that the Unit was successfully created message appears, and that the newly added hardware device appears in the Hardware List.

@@ Line 39: / Line 39: @@
 * [[Parameter: Name|Name]]
-* [[Parameter: Serial|Serial]]
+* [[Parameter: Serial|Serial Number]]
 * [[Parameter: Adapter Type|Type]]
 * [[Parameter: Location|Location]]