Modify Fax Relay Profile F
From TBwiki
(Difference between revisions)
(→List of Parameters: added two parameters) |
m |
||
| Line 1: | Line 1: | ||
| − | === '''''Applies to version v3.0''''' === | + | === '''''Applies to version v3.0, v3.1''''' === |
{{DISPLAYTITLE:Modifying FAX Relay Profile Settings}} | {{DISPLAYTITLE:Modifying FAX Relay Profile Settings}} | ||
Revision as of 08:54, 1 May 2019
Applies to version v3.0, v3.1
To configure FAX Relay settings, do the following:
1- Click Fax Relay in the Editing Profile window, to display the customizable options.
2- Modify settings as required.
3- To configure NSE, check the Use NSE checkbox.
NOTE:
If NSE exchange is possible (negociated in the SDP), the switch to passthrough will happen in the RTP stream and no longer wiil occur with a SIP re-INVITE. This implementation of NSE currently only supports a switch to passthrough, which means that you can have NSE packets switching to T.38.
- Click Save
List of Parameters
Fax/Modem Relay
- Enable Fax/Modem Relay
- Detection Mode
- Relay Mode
- Modem vs. Fax distinction timeout
- Fax/Modem tones detection duration
- Enable early Fax/Modem tone detection
- Switch to FAX relay upon CNG tone
- Expected CNG tones
- Switch to passthrough upon Bell ANS
T.38 Parameters
- Use V.34
- Maximum Bit Rate
- Fill Bit Removal
- Redundancy Count
- Transmission level (-1dBm unit)
- Prevent direct invite in T.38
Fax/Modem Pass-through Parameters
