Toolpack:Creating an IUA Cluster C
From TBwiki
(Difference between revisions)
m |
m |
||
Line 1: | Line 1: | ||
− | === '''''Applies to version(s): | + | === '''''Applies to version(s): 2.9, 2.10, 3.0, 3.2''''' === |
{{DISPLAYTITLE:Creating an IUA Cluster}} | {{DISPLAYTITLE:Creating an IUA Cluster}} | ||
After you create an IUA SAP, you must create an IUA cluster for your system. | After you create an IUA SAP, you must create an IUA cluster for your system. |
Revision as of 08:25, 26 August 2020
Applies to version(s): 2.9, 2.10, 3.0, 3.2
After you create an IUA SAP, you must create an IUA cluster for your system.
To create an IUA cluster:
1- Click IUA in the navigation panel
2- Select an IUA SAP
3- Click Create New Iua Cluster in the IUA SAP configuration window
4- Configure the new IUA cluster:
- Enter a name for the cluster
- Select a traffic mode
- Select a load share mode
- Click Create
5- Verify that the "Iua Cluster was successfully created" message appears
Path
/configurations/@[configuration_name]/hardware_units/@[hardware_name]/iua_stacks/@[iua_stack]/iua_saps/@[iua_sap]/iua_clusters/@[iua_cluster]
Parameters (text)
/configurations/@[configuration_name]/hardware_units/@[hardware_name]/iua_stacks/@[iua_stack]/iua_saps/@[iua_sap]/iua_clusters/@[iua_cluster] loadshare_mode = "PER_LINK" name = "@[iua_cluster]" traffic_mode = "ACTIVE_STANDBY" /configurations/Allyn_Config2/hardware_units/TB014369/iua_stacks/Iua0/iua_saps/IuaSap/iua_clusters/IuaCluster/advanced_parameters min_simultaneous_active_peer = 1 msg_queue_size = 16
Parameters (json)
{ "advanced_parameters" : { "min_simultaneous_active_peer" : 1, "msg_queue_size" : 16 }, "loadshare_mode" : "PER_LINK", "name" : "@[iua_cluster]", "traffic_mode" : "ACTIVE_STANDBY" }