Toolpack:Reset NetworkDevice A
From TBwiki
(Difference between revisions)
(Added Change Network Devices Roles) |
|||
| Line 3: | Line 3: | ||
Once the FreeSBC/ProSBC is configured, it is possible add or change physical IP interfaces. | Once the FreeSBC/ProSBC is configured, it is possible add or change physical IP interfaces. | ||
| − | To do so you must reset the network device role settings of the unit. | + | To do so you must reset the network device role settings of the unit. <br> |
'''Note: this will reallocate the main network controller and stop the service for a few minutes''' | '''Note: this will reallocate the main network controller and stop the service for a few minutes''' | ||
Revision as of 11:57, 31 July 2019
Applies to version(s) v3.0, v3.1
Once the FreeSBC/ProSBC is configured, it is possible add or change physical IP interfaces.
To do so you must reset the network device role settings of the unit.
Note: this will reallocate the main network controller and stop the service for a few minutes
To reset the network device role, do the following:
1- Click Hosts in the navigation panel.
2- Select the serial number of the unit.
3- Click the Status tab.
4- In the Action drop down box select Change Network Devices Roles
- Click Apply Action
After a few seconds, refresh the web interface and you will be brought back to the selection of network interfaces: Initial Configuration, Step 8
