Toolpack:M3UA Use Case A:Configure MTP3 A
From TBwiki
(Difference between revisions)
(Created page with "=== '''''Applies to version(s): v3.0''' === {{DISPLAYTITLE:Creating an MTP3 Configuration}} Once you have set up the MTP2 layer of your SS7 system, you must create an MTP3 con...") |
m (Changed response message image) |
||
| Line 19: | Line 19: | ||
[[Image:Mtp3_1_A.png]] | [[Image:Mtp3_1_A.png]] | ||
| − | 3- Verify that the '''" | + | 3- Verify that the '''"Mtp3 Stack was successfully created"''' message appears |
| − | + | ||
| − | + | ||
| + | [[Image:Mtp3_2_A_1.png]] | ||
==List of Parameters== | ==List of Parameters== | ||
Latest revision as of 13:19, 5 August 2019
Applies to version(s): v3.0
Once you have set up the MTP2 layer of your SS7 system, you must create an MTP3 configuration. MTP3 provides message routing between signaling points in an SS7 network.
To create an MTP3 configuration:
1- Select MTP3 from the navigation panel
2- Configure the new MTP3 service:
- Enter a name for the MTP3 configuration
- Make sure the Enabled and SSf Validation boxes are checked
- Select SP as the signaling point type
- Click Create
3- Verify that the "Mtp3 Stack was successfully created" message appears
List of Parameters
Timers
Advanced Parameters
