Toolpack v2.4:Edit the SCTP Configuration
From TBwiki
(Difference between revisions)
(→To edit the SCTP configuration:) |
(→To edit the SCTP configuration:) |
||
| Line 10: | Line 10: | ||
*Enter a name for the SCTP service | *Enter a name for the SCTP service | ||
| − | *Select an appropriate service type | + | *Select an appropriate service type: |
| + | *#[[RAW IP]] | ||
| + | *#[[UDP IP]] | ||
*Configure any necessary advanced parameters | *Configure any necessary advanced parameters | ||
*Click "Save" to store the configuration | *Click "Save" to store the configuration | ||
Revision as of 12:21, 8 January 2010
Stream Control Transmission Protocol (SCTP), a Transport Layer protocol, ensures reliable, in-sequence transport of messages.
To edit the SCTP configuration:
1. Select "SCTP" from the navigation panel:
2. Configure the SCTP service:
- Enter a name for the SCTP service
- Select an appropriate service type:
- Configure any necessary advanced parameters
- Click "Save" to store the configuration
3. Verify that the "Sctp Cfg was successfully updated" message appears:
