Toolpack v2.4:Create an MTP3 Configuration
From TBwiki
(Difference between revisions)
(→To create an MTP3 configuration:) |
|||
| Line 10: | Line 10: | ||
*Enter a name for the MTP3 configuration | *Enter a name for the MTP3 configuration | ||
| − | *Select | + | *Select '''SP''' as the signalling point type |
| − | *Click "Save" to | + | *Click "Save" to finalize the configuration |
[[Image:Web_Portal_v2.4_Creating_MTP3.png|700px]] | [[Image:Web_Portal_v2.4_Creating_MTP3.png|700px]] | ||
Revision as of 12:03, 26 December 2009
MTP3 provides message routing between signaling points in an SS7 network.
To create an MTP3 configuration:
1. Select "MTP3" from the navigation panel:
2. Configure the new MTP3 service:
- Enter a name for the MTP3 configuration
- Select SP as the signalling point type
- Click "Save" to finalize the configuration
3. Verify that the "Mtp3Cfg was successfully updated" message appears:
