Toolpack:Creating the M2PA Configuration A
From TBwiki
(Difference between revisions)
(Created page with ''''Note:''' M2PA replaces the MTP2 layer entirely; however, it still requires the MTP3 layer. To create an M2PA configuration: 1- Click '''M2PA''' in the navigation panel …') |
|||
| Line 9: | Line 9: | ||
2- Configure the new M2PA service | 2- Configure the new M2PA service | ||
| + | * Verify that the '''Enabled''' box is '''checked''' | ||
* Enter a '''name''' for the M2PA configuration | * Enter a '''name''' for the M2PA configuration | ||
* Change the '''Timers''' setting, if necessary | * Change the '''Timers''' setting, if necessary | ||
Revision as of 11:40, 30 June 2010
Note: M2PA replaces the MTP2 layer entirely; however, it still requires the MTP3 layer.
To create an M2PA configuration:
1- Click M2PA in the navigation panel
2- Configure the new M2PA service
- Verify that the Enabled box is checked
- Enter a name for the M2PA configuration
- Change the Timers setting, if necessary
- Click Create
3- Verify that the M2pa Cfg was successfully created message appears
